





Drain Covers
Urethane Drain Cover (Drain Blocker)
Reusable urethane drain cover that seals drains in seconds — tacky underside grips and blocks liquids during a spill; 46 × 46 cm for square drains up to 30 cm, other sizes available.
Specifications
- Material
- Urethane sealing layer with flexible top layer
- Size
- 46 × 46 cm (other sizes available)
- Thickness
- 8 mm
- Weight
- 2.7 kg
- Colour
- Yellow top / dark sealing underside
A Urethane Drain Cover is the fastest way to keep a spill out of the drainage system. When oil, fuel or chemicals escape, the drains in the floor are where the damage is done — drop this flexible mat over the grate and the spill stays on the surface, where your absorbents can pick it up.
The cover is built in two layers. The high-visibility yellow top layer is tough and flexible, so the mat can be walked on and driven into place without tearing. Underneath, the dark urethane layer is tacky and supple: it moulds itself to concrete, asphalt and uneven surfaces around the grate and forms a tight seal that blocks liquids from passing. At 46 × 46 cm it covers square drains up to about 30 cm across, with the overlap on every side that a proper seal needs. Other sizes are available — contact us with your drain size.
Use it for spill response, or leave it in place as preventive protection wherever liquids are transferred, stored or washed down — loading docks, drum stores, workshops, car parks and wash bays.
How to Use
- Sweep the area around the drain and remove debris, so the cover can seal flat.
- Peel off the clear protective film and keep it — you will need it again for storage.
- Place the cover over the drain, tacky side down, overlapping the grate by at least 8 cm on every side.
- Walk along the edges to press the cover into full contact with the surface.
- After use, wash the cover with warm soapy water and let it dry completely.
- Re-wrap it in its protective film and store it flat or rolled, ready for the next spill.
Care and Storage
Wash and dry the cover after every use, and always store it wrapped in its protective film so the tacky sides never touch each other. Store in a cool, dry place out of direct sunlight, and check the cover regularly so it is always ready. Handled this way, one cover serves for years of spill response — no single-use plastic sheeting to throw away after every incident.
Complete the Response
- Spill Kits — absorbents to clean up the spill the cover has contained
- Hazardous Waste Disposal Bags 90 × 120 cm — for disposing of the used absorbents afterwards